Hi guys,

I'm working on an M97 board with water damage and with no response whatsoever (no boot, no post, no chime, no charger light, etc.). G3HOT is available though.

After searching (a lot) I've discovered D7010 is missing, a Schottky Barrier diode between PP18V5_G3H_CHGR and CHGR_DCIN.

In my limited electronics knowledge I'm guessing this is a sensing input for the SMC. I've ordered some Schottky Diodes, but could someone tell me if this could be the source of all my problems, or should I check other stuff first, before replacing D7010?

Thanks guys, I'm learning every day on this forum! Hear hear

Kind regards,

Rick from the Netherlands