Hi guys. What pinout should I set to program the IT8587E in the GIgabyte GA-RP34W3 board. Unfortunately, I do not have a schematic from this motherboard. I have a Vertyanow Jig V3.1 programmer.

Thx for help.

Unfortunately, when I start programming the KBC, I still get a message

Check connection ...
Received ITE ID -> 8587 rev -> 06
INIT complete.
ERASE ...
ERASE complete.
The number of bytes value of FFh -> 82028
Writing, please wait ...
Error writing to flash or lost contact with ITE
2018-07-25 11:32:56

Is it possible that kbc is damaged?

perhaps.
but you'd better contact the developer, in the profile branch.

https://ascnb1.ru/forma1/viewtopic.php? ... start=2940